bed-leveling Troubleshooting

Bed leveling / first layer not sticking on the ERYONE TPU Filament 1.75mm

Source: Reddit r/3Dprinting — troubleshooting Confidence: 60% Verified Aug 9, 2026

The first layer does not adhere to the build plate, causing warping or print failure.

How to fix Bed leveling / first layer not sticking

Re-level the bed

Run the auto bed-leveling routine and adjust the Z-offset until the first layer squishes evenly.

Source: Reddit r/3Dprinting — troubleshooting Confidence: 60% Verified Aug 9, 2026
Difficulty: ★ Est. 10 min

Clean the build plate

Wipe the build plate with isopropyl alcohol to remove oils that prevent adhesion.

Source: Reddit r/3Dprinting — troubleshooting Confidence: 60% Verified Aug 9, 2026
Difficulty: ★ Est. 5 min

Replacement parts for the ERYONE TPU Filament 1.75mm

ERYONE TPU Filament 1.75mm Nozzle ERYONE TPU Filament 1.75mm Hardened Steel Nozzle ERYONE TPU Filament 1.75mm PLA Filament ERYONE TPU Filament 1.75mm Build Plate ERYONE TPU Filament 1.75mm Hotend Assembly ERYONE TPU Filament 1.75mm Magnetic Bed Sheet ERYONE TPU Filament 1.75mm PTFE Tube ERYONE TPU Filament 1.75mm Nozzle Set

← All ERYONE TPU Filament 1.75mm error codes

As an Amazon Associate we earn from qualifying purchases. Prices and availability are accurate as of the time shown and may change. We research product data independently.