bed-leveling Troubleshooting

Bed leveling / first layer not sticking on the ELEGOO PLA+ Filament 1.75mm PLA-Plus

Source: Reddit r/3Dprinting — troubleshooting Confidence: 60% Verified Aug 9, 2026

The first layer does not adhere to the build plate, causing warping or print failure.

How to fix Bed leveling / first layer not sticking

Re-level the bed

Run the auto bed-leveling routine and adjust the Z-offset until the first layer squishes evenly.

Source: Reddit r/3Dprinting — troubleshooting Confidence: 60% Verified Aug 9, 2026
Difficulty: ★ Est. 10 min

Clean the build plate

Wipe the build plate with isopropyl alcohol to remove oils that prevent adhesion.

Source: Reddit r/3Dprinting — troubleshooting Confidence: 60% Verified Aug 9, 2026
Difficulty: ★ Est. 5 min

Replacement parts for the ELEGOO PLA+ Filament 1.75mm PLA-Plus

Elegoo PLA+ Filament 1.75mm PLA-Plus Nozzle Elegoo PLA+ Filament 1.75mm PLA-Plus Hardened Steel Nozzle Elegoo PLA+ Filament 1.75mm PLA-Plus PLA Filament Elegoo PLA+ Filament 1.75mm PLA-Plus Build Plate Elegoo PLA+ Filament 1.75mm PLA-Plus Hotend Assembly Elegoo PLA+ Filament 1.75mm PLA-Plus Magnetic Bed Sheet Elegoo PLA+ Filament 1.75mm PLA-Plus PTFE Tube Elegoo PLA+ Filament 1.75mm PLA-Plus Nozzle Set

← All ELEGOO PLA+ Filament 1.75mm PLA-Plus error codes

As an Amazon Associate we earn from qualifying purchases. Prices and availability are accurate as of the time shown and may change. We research product data independently.