nozzle-clog Troubleshooting

Nozzle clogged on the ANYCUBIC PETG Filament 1

Source: Reddit r/3Dprinting — troubleshooting Confidence: 60% Verified Aug 9, 2026

The nozzle is blocked and filament stops extruding, causing under-extrusion or a failed print.

How to fix Nozzle clogged

Cold-pull the nozzle

Heat the nozzle to 200C, push filament through, then pull it out cold to clear the clog.

Source: Reddit r/3Dprinting — troubleshooting Confidence: 60% Verified Aug 9, 2026
Difficulty: ★★ Est. 10 min

Replace the nozzle

If the clog persists, replace the nozzle with a genuine spare.

Source: Reddit r/3Dprinting — troubleshooting Confidence: 60% Verified Aug 9, 2026
Difficulty: ★★ Est. 15 min

Parts needed: Anycubic PETG Filament 1 Nozzle, Anycubic PETG Filament 1 Hardened Steel Nozzle, Anycubic PETG Filament 1 Nozzle Set

Replacement parts for the ANYCUBIC PETG Filament 1

Anycubic PETG Filament 1 Nozzle Anycubic PETG Filament 1 Hardened Steel Nozzle Anycubic PETG Filament 1 PLA Filament Anycubic PETG Filament 1 Build Plate Anycubic PETG Filament 1 Hotend Assembly Anycubic PETG Filament 1 Magnetic Bed Sheet Anycubic PETG Filament 1 PTFE Tube Anycubic PETG Filament 1 Nozzle Set

← All ANYCUBIC PETG Filament 1 error codes

As an Amazon Associate we earn from qualifying purchases. Prices and availability are accurate as of the time shown and may change. We research product data independently.