nozzle-clog Troubleshooting

Nozzle clogged on the ELEGOO PLA+ Filament 1.75mm PLA-Plus

Source: Reddit r/3Dprinting — troubleshooting Confidence: 60% Verified Aug 9, 2026

The nozzle is blocked and filament stops extruding, causing under-extrusion or a failed print.

How to fix Nozzle clogged

Cold-pull the nozzle

Heat the nozzle to 200C, push filament through, then pull it out cold to clear the clog.

Source: Reddit r/3Dprinting — troubleshooting Confidence: 60% Verified Aug 9, 2026

Difficulty: ★★ Est. 10 min

Replace the nozzle

If the clog persists, replace the nozzle with a genuine spare.

Source: Reddit r/3Dprinting — troubleshooting Confidence: 60% Verified Aug 9, 2026

Difficulty: ★★ Est. 15 min

Parts needed: Elegoo PLA+ Filament 1.75mm PLA-Plus Nozzle, Elegoo PLA+ Filament 1.75mm PLA-Plus Hardened Steel Nozzle, Elegoo PLA+ Filament 1.75mm PLA-Plus Nozzle Set

Replacement parts for the ELEGOO PLA+ Filament 1.75mm PLA-Plus

Elegoo PLA+ Filament 1.75mm PLA-Plus Nozzle Elegoo PLA+ Filament 1.75mm PLA-Plus Hardened Steel Nozzle Elegoo PLA+ Filament 1.75mm PLA-Plus PLA Filament Elegoo PLA+ Filament 1.75mm PLA-Plus Build Plate Elegoo PLA+ Filament 1.75mm PLA-Plus Hotend Assembly Elegoo PLA+ Filament 1.75mm PLA-Plus Magnetic Bed Sheet Elegoo PLA+ Filament 1.75mm PLA-Plus PTFE Tube Elegoo PLA+ Filament 1.75mm PLA-Plus Nozzle Set

← All ELEGOO PLA+ Filament 1.75mm PLA-Plus error codes

As an Amazon Associate we earn from qualifying purchases. Prices and availability are accurate as of the time shown and may change. We research product data independently.