bed-leveling Troubleshooting

Bed leveling / first layer not sticking on the 3DLAC Sprühkleber

Source: Reddit r/3Dprinting — troubleshooting Confidence: 60% Verified Aug 9, 2026

The first layer does not adhere to the build plate, causing warping or print failure.

How to fix Bed leveling / first layer not sticking

Re-level the bed

Run the auto bed-leveling routine and adjust the Z-offset until the first layer squishes evenly.

Source: Reddit r/3Dprinting — troubleshooting Confidence: 60% Verified Aug 9, 2026
Difficulty: ★ Est. 10 min

Clean the build plate

Wipe the build plate with isopropyl alcohol to remove oils that prevent adhesion.

Source: Reddit r/3Dprinting — troubleshooting Confidence: 60% Verified Aug 9, 2026
Difficulty: ★ Est. 5 min

Replacement parts for the 3DLAC Sprühkleber

3DLAC Sprühkleber Nozzle 3DLAC Sprühkleber Hardened Steel Nozzle 3DLAC Sprühkleber PLA Filament 3DLAC Sprühkleber Build Plate 3DLAC Sprühkleber Hotend Assembly 3DLAC Sprühkleber Magnetic Bed Sheet 3DLAC Sprühkleber PTFE Tube 3DLAC Sprühkleber Nozzle Set

← All 3DLAC Sprühkleber error codes

As an Amazon Associate we earn from qualifying purchases. Prices and availability are accurate as of the time shown and may change. We research product data independently.